" /> BANDAI MG Gundam Strike Freedom Build #2 Detail up ”I want to make equipment with a 3D printer!” - 試行錯誤のガンプラ作成 ”Trial and error Gunpla Build"

BANDAI MG Gundam Strike Freedom Build #2 Detail up ”I want to make equipment with a 3D printer!”


I would like to customize the details of Strike Freedom.
I would like to create a new atmosphere while maintaining the basic image.
I have a lot of things I want to do, but once I start it, it will take a long time to complete, so I will change it in two places.
A rifle and back dragoon system.
I thought that a larger rifle would be cooler and changed it
I would like to join the dragoon system with conventional parts in order to improve the rank as a beginner.I don’t think the hurdles are very high, so I’d like to try it!



In addition to the attached weapon rifle, I would like to make a long weapon that is somewhere between the bird rifle and the long rifle.

1st output

I output it the first time, but it was small …
I want to make it one size larger. Furthermore, when creating data, I made too thin a lump and it wavy after the output was completed. No charm at all

Move on to the next output without cutting the support material.

Second output

It might have been a little too big …
For the time being, I will continue to create it as it is. Long is usually cool.
Although the size is good, the thin part is still wavy, so adjust the data and output again.

3rd output

The wavy part has been eliminated considerably, so it is complete. It is completed by gate processing and sanding of the support material to some extent.

Super dragoon

1st output

1st output
Output for the time being with a rifle to check the size and atmosphere.
The size was just right, so I added data while considering the connection with the dragoon!

Second output

I was able to output cleanly.
However, 4 out of 8 dragoons were connected well, but the remaining 4 dragoons have different shapes and I have to start over.

When joining, you can easily fit it by acclimatizing a drill of a slightly different size.
I tried to size it with a caliper and output it in that size, but there seems to be some error.

3rd output

3rd output

I was able to install all the dragoons.
I made a lot of extra output including carelessness. Well, if you are a beginner, it will be like this.


I was able to make the target rifle and dragoon system on the back.
There is still something I want to do when it is completed, but this time I will finish the 3D printer around here. After that, I would like to recover by painting.

I used a 3D printer for the first time in a long time, but although I was ignorant, it was a lot of fun and the blog update was delayed far beyond the scheduled time.I would like to challenge it more and more. It is recommended for those who are looking for a new stimulus for plastic models.Why don’t you give it a try?


There was a problem that it fell off the display stand and broke when it was about to be completed. I managed to fix it using adhesive or brass wire.One rifle is also broken and re-output. In many cases, the joints of the parts are broken.From now on, we will make the joints stronger.

Creation related with 3D printer