BANDAI MG Gundam Storm Bringer F.A. Build # 1 Temporary Assembly / Painting Preparation


Hello, I’m the caretaker.
I’m going to do a temporary assembly of Storm Bringer.


This time, there were quite a lot of parts because Jim Turbulence’s parts were also included, so I made it with Gundam Storm Bringer F.A. (Fatal Ash), so there are quite a lot of parts. Can I use it for something?
There are quite a few runners because there are parts that are diverted from various kits.

Points you want to change

I feel like I want something in the propeller tank on my back, the shoulder cannon, and my left hand.
Since the frame uses Jim Sniper II, there is a lot of freedom in poses, so I want to make weapons that make use of that area.
A kit that expands your dreams.


Temporary assembly is complete.
It’s cool. The range of movement is wide and the range of poses is wide. The unpainted color is also cool, so I will paint based on this color.
As a kit, a little joint erasing will occur on the weapon. You can see the joints of the ankle armor, but I’d like to think a little about this and pass through the joints.

Next, I would like to improve the details.
I want to make the propeller tank on my back smaller and more like a tank.

Thank you for watching until the end.