" /> BANDAI RG Evangelion Unit 1 Build #3 Painting - 試行錯誤のガンプラ作成 ”Trial and error Gunpla Build"

BANDAI RG Evangelion Unit 1 Build #3 Painting


Hello, I’m the caretaker.
This time I will proceed with painting.



I mainly painted the paint I have. I bought a new purple and fluorescent green to make RG Evangelion this time, but I didn’t use fluorescent gree because it was a green clear part.

Surfacer 1500 Black → Purple

Surfacer 1500 Black → Metallic Black

Surfacer 1000 White → Orange

Surfacer 1200 gray → MS Red

Inner parts
Surfacer 1500 Black → Matte Black


The purple parts are painted with gradation and the other parts are painted with solid.


I used a decal I bought separately. There was also an accident where the decals other than the first machine were also attached and the decals of the zero machine were pasted. It was dried overnight, so it was stuck firmly, so I had a hard time peeling it off.

The method of removing the water-based decal was to moisten the mark softer on tissue paper and leave it for about 1 hour to remove it relatively easily. Glue remains and needs to be cleaned cleanly.

Top coat

It is completed by clearing the finish. Many of the paints I used this time were glossy, so I applied Super Clear to the outer parts, leaving the inner parts such as joints.


This is the end.
It’s pretty cool. I’m not good at making it because it’s glossy, but it was a very fun painting. I also want to practice gloss painting.

The gree part was a clear-like part and the color was nice, so I finished it only with clear without coloring.

This completes the painting of the main body.

Thank you for watching until the end.