" /> BANDAI MG Dwadge Build #2 Detail up - 試行錯誤のガンプラ作成 ”Trial and error Gunpla Build"

BANDAI MG Dwadge Build #2 Detail up


Hello, I’m the caretaker.

This time I would like to improve the details for the first time in a long time.


Plastic board

I pasted a plastic van made with HG detail punch on the shoulder and waist armor.
It is an interesting tool that you can easily make a plastic van of the same shape.

HG detail punch

Four types of HG detail punches are on sale. Since the shape of the cut is different, I think you should use it properly according to the purpose. The trapezoid ① is used in the dwadge this time. The stormbringer I made earlier uses a layered glue.

Manufacturer site

HG ディテールパンチ 台形① | 株式会社ウェーブ
連続的な形状をワンタッチで打ち抜ける! ディテールアップ用の自作パーツの作成に便利なパンチ!

Metal parts

I made a 1mm hole and there is a protrusion on the back side of the metal part, so I insert it and fix it.
It can be firmly fixed just by fitting it in, and the details can be easily improved.

Mesh pipe

I changed the power pipe on the shoulder to a mesh pipe.
Since the pipe part is a separate part, it feels like removing it, cutting it to the right length, and inserting the mesh pipe. it’s simple.


It’s a modest detail up, but it’s done around here.

I’m not good at improving details, so I’ll leave it in moderation.
Since the HG detail punch is just cut and pasted, it is very easy to improve the detail and it is helpful. It is recommended because you can easily make a rear mesh pipe.
This time it’s over here. Next time, I will paint the weapons.

Thank you for watching until the end.